12/20/2023 0 Comments Xbar reviewsAdded the orange background that warns that the configuration of one of the Wizard panels has not been completed also in panels 9 (Tail Rotor Setup), 10 (Blades Size) and 13 (Flying Style).Added a new message box “No Firmware selected” that appear if in the Firmware selection no firmware was selected before click on “Upload Now”.Added in the Firmware update progress windows the red phrase “Do not disconnect and do not remove power and do not close the program until the update process is finished !!!”.This is because by analyzing the external event memory of the Flight Control Units that came back with the processor ROM erased and/or altered, we have seen that in these returns the events "Voltage 4,3V" are always present Added a power supply voltage check that prevents the firmware update process from starting if the voltage is too low.For now selectable only from the protocols drop-down menu in: ADVANCED => Common => Receiver Added decoding of the new F.Bus protocol used with the new FrSky ETHOS transmitters.Added for deeper diagnostic purpose purple events for the following YGE, Kontronik, Scorpion, Platinum V5 errors: “ESC: Low voltage protection”, “ESC: Over current protection”, “ESC: Over temperature protection”.Added decoding of the new Platinum V5 protocol of Hobbywing (used for now only on new Platinum V5 150A).Added (only for combustion models that have a clutch: “Is Electric” not selected), the new “Failsafe Idle value” that prevents combustion engines from shutting down in the event of short radio signal interruptions (Fail Safe).Xbar devices are slated to begin shipping to customers in September, at which time its retail price will be roughly $230, according to the campaign. The Kickstarter campaign launched by the Chinese company on May 11 surpassed its $5,000 funding goal in about 10 minutes, and is now up to more than $80,000 with a month remaining. Through our specially designed valve, the rate of pressure rise can be flexibly controlled, and achieve truly complete pressure profiling.” It is best to use a gas charge, because it is a high-pressure liquid gas. “The output of the electric air pump is more stable, and the effect will be better. “The manual bike pump can be used to brew espresso, but the gas output is unstable,” the company said. The company recommends the CO2 method when possible for the smoothest extraction and best stability, followed by the bike pump option. ![]() Xbar makes up for these shortcomings affordable, portable and stable.” Most manual espresso machines tend to be expensive and bulky, and the pressure is often unstable. “After more than two years of continuous improvement of Xbar, Xbar became a mature espresso machine. “At the beginning, Xbar was designed for ’s own use,” Xbar told Daily Coffee News. Xbar said the designer of the device, Qiu Meng, originally sought to improve upon existing manual espresso makers by creating more pressure stability.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |